Page 1
9759923 with seff-cJeaning oven Pages Before you start Product dimensions Cabinet dimensions/requirements Tip Over Hazard Electrical requirements A child or adult can tip the range be killed, Installation steps Connect anti-tip bracket to rear Check operation range foot. if range does not operate Reconnect the anti-tip bracket,...
Mobile home installation Before you start... ToMs needed: The installation of this range must conform with the Manufactured Home Assemble the required tools and parts Your safety and the safety Construction and Safety Standard,Title before starting installation. Read and others are very important.
Electrical requirements if codes permit and a separate ground mf connecting a four-wire The range can be connected directly wire is used, it is recommended that to the fused disconnect (or circuit breaker system: quaiified eiectrician determine that the box) through flexible armored...
Page 4
Now start... EJectricaJ connection [] Remove the terminal block cover Excessive Weight Hazard screws located on the back of range, Puii Use two or more people to move cover down and towards you to remove install range. from range, cover Failure to do so can result in back or...
Page 5
Power suppJy cord method: Use a 1/4" nut driver and remove Use either ring-type terminals hex washer head screws from spade terminals with upturned ends terminal blocks, to connect the power supply, 10, Connect the neutral (center) wire Complete electrical connection according to your...
Page 6
Direct wire method: Copper or Aluminum wire Four=wire electrical Three-wire eUectrica[ connection: connection: Use this method for new installations, Use this method only if local codes mobile homes, recreational vehicles permit connecting ground conductor whenever four-wire installation neutral supply wire. required.
Operating position Before moving range across floor, check If range is not level, pull range forward that range is still on cardboard shipping If installing the range in a mobile until rear leveling leg is removed from base to protect floor covering. the anti4ip bracket.
Moving the range When moving range, sH[de range onto cardboard or hardboard to prevent damaging the floor covering. If removing the range is necessary cleaning or maintenance: UnpHug range or disconnect power. SH[de range forward to compHete cHean[ng or maintenance. Make sure the ant[4[p...