Jenn-Air JDR8895BAS13 Installation Instructions Manual page 9

! _'_ _, _ _ ,,_,u_ _ _
n } Bf ( cket
1. Remove the anti-tip bracket that is taped inside the upper Floor Mounting
oven with the literature package.
2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor you can use the wall
mounting method.
3. Determine and mark edge of range in the cutout space. The
mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout
so that right (or left) edge of the bracket is 1%6" (2.4 cm) from
the marked edge of the range, as shown.
4=
A
B
A. Anti-tip bracket
B. Mark edge of range
C. 1%6" (2.4 cm)
Drill two ½" (3.0 mm) holes that correspond to the bracket
holes of the determined mounting method. See below.
Wall Mounting
A B
\
A. #12 x 1%" screws
B. Anti-tip bracket
5=
A. #12 x 1%" screws
B. Anti-tip bracket
Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 15/8 '' screws provided.