Jenn-Air JDR8895BAS13 Installation Instructions Manual page 4

30" (76.2 cm) double oven dual fuel ranges
Table of Contents

Advertisement

Available languages

Available languages

Cabinet opening d imensions
thatareshown m ust b eused.
Given dimensions
areminimum clearances.
The flooranti-tip bracket must b einstalled. Toinstall theanti-
tipbracket shipped w iththerange, see"Install Anti-Tip
Bracket" section.
• Grounded electrical supply isrequired. See "Electrical
Requirements"
section.
• Proper gas supply connection must b eavailable. See "Gas
Supply R equirements"
section.
• Contact aqualified floorcovering installer tocheck t hatthe
floorcovering canwithstand atleast 2 00°F ( 93°C).
• Use aninsulated pador1¼,, (0.64 cm)plywood under range if
installing range o ver c arpeting.
IMPORTANT:
Toavoid damage toyour c abinets, check w ithyour
builder orcabinet supplier tomake sure thatthematerials used
will n otdiscolor, delaminate orsustain o ther d amage. This oven
hasbeen designed inaccordance withtherequirements
ofUL
andCSA International
and complies withthemaximum a llowable
wood cabinet temperatures
of194°F ( 90°C).
Mobile Home - Additional
Installation
Requirements
The installation of this range must conform to the Manufactured
Home Construction
and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280). When such standard is not
applicable, use the Standard for Manufactured
Home
Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this range must conform with the
current standards CAN/CSA-A240-1atest
edition, or with local
codes.
Mobile home installations require:
When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing
the range is adequate as long as it conforms to the standards
listed above.
Four-wire power supply cord or cable must be used in a
mobile home installation. The appliance wiring will need to be
revised. See "Electrical Connection"
section.
Product Dimensions
A
A. 357/8'' (91.1 cm) cooktop
height (minimum) with
leveling legs screwed all the
way in*
B. Model/serial/rating
plates
(located behind the control
panel)**
C. 467/8 '' (119.1
cm) overall
height
(minimum)
with leveling
legs
screwed
all the way in*
D. 28" (71.1 cm) depth
with
handle
E. 265/16 '' to 27¼"
(66.8
to 69.2
cm)***
F. 297/8 '' (75.9
cm) width
*Range can be raised approximately
1" (2.5 cm) by adjusting
the leveling legs.
**Model/serial/rating
plates may be rotated up from behind the
control panel for viewing from the front of the range.
***Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle
installation.
Cabinet Dimensions
Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT:
If installing a range hood or microwave hood
combination
above the range, follow the range hood or
microwave hood combination
installation instructions
for
dimensional clearances above the cooktop surface.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jdr8895baw13Jdr8895bab13

Table of Contents