Advertisement
RANGE ADJUSTMENTS
Top Section
- Gas Top Pilot Adjustment
(See figure 6)
Purge all air from supply system by turning on one top
burner valve. Then turn off valve and adjust top pilot flame
using adjusting screw "A" (figure 6) so that flame is even
with top of flash tube. To light the burner, push and turn
top burner knob to the lite position. NOTE: Some models
have ONLY one pilot adjustment at the manifold pipe.
LOT
ADJUSTMENT
SCREW
"A"
PILOT
TOP
OF
ART#
9219
658
FIGURE 6
Top Section
- Electric
Ignition
To operate, push and turn top burner knob to the LITE
position. The top burner will light. To turn OFF spark after
the top burner has ignited turn knob to Ht setting.
CLEANING
INSTRUCTIONS
FOR:
BURNER
CAPS
AND SEALED
GAS
BURNERS
• Allow burner to cool. Remove burner cap and wash in
soapy water with a plastic scouring pad or in the
dishwasher. For stubborn soils, clean with a
soap-filled, nonabrasive pad or Cooktop Cleaning
Creme (Part #20000001 ).
• For burned on soil, place burner cap on newspaper
and spray with commercial oven cleaner. Follow
manufacturer's directions.
• Clean gas ports with a straight pin especially the port
below the ignitor. Do not enlarge or distort holes.
• Be careful not to get water into burner ports.
• When cleaning, use care to prevent damage to the
ignitor. If the ignitor is soiled, wet or damaged the
surface burner will not light.
Top Burner Adjustment
All Top Burner Valves: The approximate height of the
flame at the high or full-on position is shown below.
Adjust burner air shutter to the widest opening that will not
cause the flame to lift or blow off the burner when cold.
NOTE: Correctly adjusted sealed burners, can have
flames that will lift or blow off without a pot over the
burner. These should be adjusted with a pot in place.
CONVENTIONAL
BURNERS
*1
.J
AIR
SHU[TER
SEALED BURNERS
F/GURE 7
-7-
Advertisement
