Advertisement
ORIFICE
CONVERSION
=
From Natural Gas To LP/Propane Gas:
a.
Change the appliance pressure regulator from
natural to LP setting. (See figure 12, 13 or 14).
b.
Screw the burner orifice hoods down tight against
the pins. (See figure 15B). Use care to not over
tighten. Over tightening can damage the coaxial
pin inside the orifice hood.
NOTE: On units using Eaton Oven Safety Valve,
screw the valve orifice hood down tight against
the valve body. (See figure 15D). It is important
that the hood be turned down as far as it can go
to insure that complete conversion has occurred.
c.
Models with standing pilots: Adjust burner pilots.
(See figure 6). Turn the selector switch on the
face of the thermostat to the LP position.
d.
Adjust burner air shutter to the widest opening
that will not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners, can
have flames that will lift or blow without a pot over
the burner. These should be adjusted with a pot in
place.
,
From LP/Propane
Gas To Natural Gas:
a.
Change the appliance pressure regulator from LP
to natural setting. (See figure 12, 13 or 14).
b.
Screw the burner orifice hoods away from the
pins. (See figure 15A). Approximately
1 1/2 to 2
turns.
NOTE: On units using Eaton Oven Safety Valve,
screw the burner orifice hoods away from pin (see
figure 15C). Approximately
1 1/2 to 2 turns.
c.
Models with standing pilots: Adjust top burner
pilots. (See figure 6). Turn the selector switch on
the face of the thermostat to the Nat. position.
d.
Adjust burner air shutter to the widest opening
that will not cause the flame to lift or blow off the
burner when cold.
NOTE: Correctly adjusted sealed burners, the
flame will lift or blow without a pot over the burner.
These should be adjusted with a pot in place.
SERVICE-
PARTS INFORMATION
When your range requires service or replacement parts,
contact your dealer or authorized service agency. Please
give the complete model and serial numbers of the range
which is located on the range model number plate.
FOR ALL TOP BURNER
AND
OVEN
SAFETY
VALVE
CONVERSION
(EXCEPT
EATON
VALVE)
ORIFICE
HOOD_
ART
# 92_9-983-O
.j
FIGURE 15A
FIGURE 15B
NATURAL GAS
LP GAS
SETTING
SETTING
FOR EATON
OVEN
SAFETY
VALVE
CONVERSION
FIGURE 15C
FIGURE 15D
NATURAL GAS
LP GAS
SETTING
SETTING
HOW TO REMOVE
RANGE FOR
CLEANING
AND SERVICING
Follow
these
procedures
to remove
appliance
for
cleaning or servicing:
1. Shut off gas supply to appliance.
2. Disconnect electrical supply to appliance, if equipped.
3. Disconnect gas supply tubing to appliance.
4. Slide range forward to disengage range from the
anti-tip bracket. (See page 4).
5. Reverse procedure to reinstall. If gas line has been
disconnected,
check for gas leaks after reconnection.
NOTE:
A qualified
servicer
should
disconnect
and
reconnect the gas supply.
6. To prevent range from accidentally tipping, range must
be secured to the floor by sliding rear leveling leg into
the anti-tip bracket.
-10-
Advertisement
