Jenn-Air JB36SEFXRB Installation Manual page 24

3=
A _
4=
5.
Slide the custom panels into the trims on the refrigerator
door(s) and freezer drawer, making sure that the backer panel
fits into the hinge side trims.
............................ L ..........
A. Panels
Reinstall the trims and corner caps.
Remove the skin from the screw covers. Snap the screw
covers into the handle trim section.
3. Remove one end cap by loosening the nuts and sliding the
end cap off.
A
C ...........
A. Bottom rail C. End cap
B. Nuts D. Top rail
4. Slide the custom panel into the top grille channel and reattach
the end cap.
5=
A. Custom panel
Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B A B
A. Top grille
B. Cabinet side trims
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel-side down on a soft working surface.
B A B
Door Alignment (36" [91.4 cm] Models)
1. Loosen, but do not remove, the four Torx®t27 flat-head
mounting screws and the two 1/4"hex-head mounting screws
in the top hinge.
2. Adjust the top hinge of the door to align it.
3. Tighten the Torx ®t27 flat-head mounting screws to a torque of
approximately 100 inch-pounds (11.3 Nm).
4. Tighten the 1/4"hex-head screws.
A. Top grille
B. Cabinet side trims
A. Torx ®t27 flat-head mounting screws
B. _" hex-head mounting screws
24