7. To confirm that the option is installed correctly, print a status
sheet. See "Printing a Status Sheet" on page 393.
Note for Macintosh users:
When you have attached or removed product options, you need to
delete the product using Print Setup Utility (for Mac OS X 10.3)
or Print Center (for Mac OS X 10.2 or below), and then re-register
the product.
Removing a memory module
Caution:
c
Before you remove a memory module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
Warning:
w
Be careful when working inside the product as some components
are sharp and may cause injury.
Perform the installation procedure in reverse.
When removing a memory module from its slot, press the clip
and pull out the memory module as shown below.
Installing Options
10
10
10
10
10
10
10
10
10
10
10
10
335