Loading/Ejecting An Ls-120 Disk - Fujitsu LifeBook S-4530 Instructions Manual

Loading/Ejecting an LS-120 disk

This item explains how to load/eject an LS-120 disk in/from the LS-120 disk drive.
Loading an LS-120 disk
Insert an LS-120 disk into the LS-120
disk drive.
Insert an LS-120 disk into the LS-120 disk
drive with its label side up and the shutter
facing inwards.
Critical Point
Since the LS-120 disk drive of this personal computer locks the
disk electronically, any LS-120 disk can be ejected only when
the personal computer is in the operating mode. If the LS-120
disk is not ejected for some reason, insert the tip of a paper clip
into the EJECT hole. The disk will be ejected.
Ejecting an LS-120 disk while the LS-120 disk drive access lamp
or on the status indicator LCD is lighted might damage the
data recorded on the disk.
To protect data stored in an LS-120 disk from erasure or to prevent additional data writing on
a disk, slide the write enable tab of disk to make the square hole open (write inhibit status). To
make the disk enabled for overwriting or additional writing, slide the write enable tab again to
shut the square hole (write enabled status).
Ejecting an LS-120 disk
Press the EJECT button.
EJECT button
Before pressing the EJECT button, make sure
that both the LS-120 disk drive access lamp
and on the status indicator LCD are not
displayed.
49