Bobbin Winding - Husqvarna Viking Mega Quilter User Manual

Bobbin winding

1. Pull the thread stand up as far as it will
go and turn it around until it clicks into
position.
2. Pass the thread through the guide (A)
on the thread stand from behind.
3. Pass the thread through the second
thread guide (B).
4. Pass the thread under the bobbin
winding tension disk (C).
5. Thread through the hole (D) in the
bobbin from the inside to the outside.
Place the bobbin on the bobbin winder
spindle by matching the slit in the
bobbin with the spring on the bobbin
winder spindle (E).
6. Push the bobbin winder stop to the left
(F).
7. Hold the end of the thread and press
the bobbin winding button. Press the
bobbin winding button again to stop
the bobbin when it has made several
turns, and cut the thread close to the
hole in the bobbin.
8. Press the bobbin winding button again.
The MEGA QUILTER™ will stop
automatically when the bobbin is full
and the bobbin winder stop will return
to the original position.
9. Cut the thread with scissors. Remove
the bobbin from the bobbin winder
spindle.
Note: The MEGA QUILTER™ has an
exclusive motor for bobbin winding, which allows
you to wind a bobbin while sewing.
Operating your MEGA QUILTER™
16
C
D
E
A
B
F