Attaching The Darning Plate; Placing A Thread Spool On The Spool Pin; Placing A Thread Cone On The Spool Pin - Husqvarna Viking Mega Quilter User Manual

Attaching the darning plate

If you want to feed the fabric free motion, for
instance when stippling, you should use the
darning plate (A) that has been provided with your
MEGA QUILTER™.
To attach the darning plate you should start by
raising the presser foot lifter. Raise the needle to
its highest position by pressing the Needle Up/
Down button twice.
Switch off the main switch and
unplug the machine.
Remove the two set screws and remove the
standard needle plate. Put the darning plate in
place and secure it with the two set screws.
Placing a thread spool on the
spool pin
Place a spool of thread on the spool pin and put
a spool cap firmly against the spool. The thread
should come off the spool as shown in the
picture.
Placing a thread cone on the
spool pin
If you are using a large thread cone, use a spool
holder to hold the cone in place. Put the spool
holder (B) on the spool pin, then place the thread
cone on the spool holder.
Note: If the cone is wobbly when sewing, cover the thread
cone with the net that comes with the machine.
Operating your MEGA QUILTER™
15
A
B