Weslo Pursuit T 149 Bike User Manual page 7

8. Attach the Pivot Bracket (53) to the Upright (13) with
the Pivot Clamp (54) and the Pivot Handle (55).
Note: The Pivot Handle functions like a ratchet. Turn
the Pivot Handle clockwise, pull it away from the
Upright, turn it counterclockwise, push it toward the
Upright, and then turn it clockwise again. Repeat this
process until the Pivot Handle is tight.
While a second person holds the Console (16) near
the Upright (13), insert the console wire through the
Pivot Bracket (53) and connect it to the Extension
Wire (23). Then, insert the excess wire downward
into the Upright.
Attach the Console (16) to the Pivot Bracket (53)
with four M6 x 15mm Button Screws (46). Be care-
ful to avoid pinching the wires.
9. Attach the Left and Right Pivot Covers (50, 51)
around the Upright (13) with an M4 x 15mm Round
Head Screw (60) and two M5 x 15mm Round Head
Screws (61).
10.Identify the Left Pedal (24), which is marked with an
"L." Using an adjustable wrench, firmly tighten the
Left Pedal counterclockwise into the left arm of the
Crank (21). Tighten the Right Pedal (not shown)
clockwise into the right arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, keep the
Pedals tightened.
Adjust the strap on the Left Pedal (24) to the desired
position, and press the end of the strap onto the tab
on the side of the Left Pedal. Adjust the strap on the
Right Pedal (not shown) in the same way.
11. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
8
Be careful to
avoid pinching
the wires.
23
13
46
9
50
61
60
10
24
Strap
7
16
Console Wire
53
54
46
51
13
21
55
61