Weslo Pursuit T 149 Bike User Manual page 10

In addition, the
pace meter on
the right side of
the display will
provide a visual
representation of
your pedaling
pace. As you
increase or
decrease your
pace, indicators will appear or disappear in the
pace meter.
To cancel the scan mode, press the Display but-
ton. The indicator below the word SCAN will dis-
appear. The upper section of the display will then
show only the elapsed time, and the lower left
section of the display will show only the number
of calories you have burned. If you press the
Display button again, the upper section of the dis-
play will show only the distance pedaled, and the
lower left section of the display will show only the
number of fat calories you have burned. To select
the scan mode again, press the Display button
repeatedly until an indicator appears below the
word SCAN.
Note: The console can display speed and dis-
tance in either miles or kilometers. The letters
MPH or KM/H will appear in the display to show
which unit of measurement is selected. To change
the unit of measurement, hold down the On/Reset
button for several seconds until the desired unit of
measurement appears in the display.
To reset the display, press the On/Reset button. To
pause the console, stop pedaling. When the con-
sole is paused, the time will flash in the display.
To continue your workout, simply resume pedal-
ing.
5
Measure your heart rate if desired.
Note: If there
are sheets of
clear plastic on
the metal con-
tacts of the
handgrip pulse
Pace Meter
sensor, remove
the plastic. To
measure your
heart rate, hold
the handgrip
pulse sensor with
your palms resting against the metal contacts.
Avoid moving your hands or gripping the con-
tacts tightly.
When your pulse is detected, the heart-shaped
indicator in the display will flash each time your
heart beats and two dashes will appear. After a
moment, your heart rate will be shown in the dis-
play. For the most accurate heart rate reading,
continue to hold the handgrips for about 15 sec-
onds. Note: If you continue to hold the handgrip
pulse sensor, the display will show your heart rate
for up to 30 seconds. The display will then show
your heart rate along with the other modes.
If your heart rate is not shown, make sure that
your hands are positioned as described. Be care-
ful not to move your hand excessively or to
squeeze the metal contacts too tightly. For opti-
mal performance, clean the metal contacts using
a soft cloth; never use alcohol, abrasives, or
chemicals to clean the contacts.
6
When you are finished exercising, the console
will turn off automatically.
If the pedals do not move for a few seconds, the
time will flash in the display and the console will
pause. If the pedals do not move for a few min-
utes, the console will turn off and the display will
be reset.
10
Metal
Contacts