Weslo Pursuit T 149 Bike User Manual page 5

3. Attach the Left and Right Frame Covers (59, 3)
around the Frame (1) with an M4 x 15mm Round
Head Screw (60) and two M5 x 15mm Round Head
Screws (61) as shown.
4. Attach the Seat (12) to the Seat Carriage (58) with
four M8 Split Washers (42) and four M8 Nylon
Locknuts (10). Note: The Split Washers and the
Nylon Locknuts may be pre-attached to the
underside of the Seat.
Remove the Seat Knob (56) from the Seat Post (5).
Place the Seat Carriage (58) on the Seat Post and
insert the Seat Knob through the Seat Post into the
hole in the Seat Carriage. Then, tighten the Seat
Knob. Make sure the Seat Knob is engaged in the
hole in the Seat Carriage.
5. Turn the Seat Post Knob (9) counterclockwise and
remove it from the Frame (1). Next, insert the Seat
Post (5) into the Frame. Adjust the Seat Post to the
desired height and insert the Seat Post Knob
through the indicated hole in the Frame into one of
the adjustment holes in the Seat Post. Then, turn the
Seat Post Knob clockwise until it is tight. Make sure
the Seat Post Knob is firmly engaged in one of
the adjustment holes in the Seat Post.
3
59
60
61
4
12
42
10
5
5
1
5
3
61
1
58
42
10
56
Adjustment
Holes
5
Hole
9