Weslo Pursuit T 149 Bike User Manual page 6

6. While another person holds the Upright (13) near
the Frame (1) as shown, connect the Extension
Wire (23) to the Reed Switch Wire (39). Next, con-
nect the Resistance Cable (19) to the Lower
Cable (29) in the following way:
• See drawing A. Pull up on the metal bracket on
the Lower Cable (29), and insert the tip of the
Resistance Cable (19) into the wire clip inside of
the metal bracket as shown.
• See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of the
metal bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (23, 39) and the Cables (19, 29)
downward into the Frame (1).
Next, insert the Upright (13) into the Frame (1). Be
careful to avoid pinching the wires and cables.
Attach the Upright with three M8 x 15mm Button
Screws (34) and three M8 Split Washers (42).
7. The Console (16) requires four AA batteries; alkaline
batteries are recommended. Press the tab on the
battery cover and remove it. Insert four batteries into
the Console as shown. Make sure that the batter-
ies are oriented as shown by the diagram on the
battery cover. Then, reattach the battery cover.
6
13
23
19
39
29
42
34
1
A
Metal
Bracket
19
29
7
6
Be careful to
avoid pinching
the wires and
cables.
42
34
C
B
Metal
19
Bracket
29
Battery Cover
Batteries
16