Setting The Time And Date; Bottle Setup Mode - Hach SIGMA 900 Instrument Manual

4.3 Setting the Time and Date

Note: When setting the time and
date, the key causes the display to
*
back up to the previously flashing
character.

4.4 Bottle Setup Mode

8544operations.fm
Before programming the sampler for the first time, check the real time clock
and date settings.
1. Check the real-time clock and date settings by pressing
display will show the time and date for several seconds:
10:35 AM 24OCT00
2. If the time or date are not correct, press
appear on the display, with the hour flashing.
3. Press the appropriate numerical key(s) for the correct hour. When the
correct hour flashes on the display, press
to flash on the display.
4. Using the same procedure, select the correct minutes and press
am/pm indicator will flash.
5. If the desired indicator is flashing on the display, press
indicator is not flashing, press
to flash.
6. Press . The month will begin to flash. Select the correct day, month
YES
and year using the same procedure as you used to set the time.
7. After the correct year has been entered, the display will read
"Synchronize Time-enter at Time
display will read "Clock is Now Set
When programming the sampler for the first time, you must first access the
bottle setup mode which contains set-up information such as the units for
bottle volume (milliliters and gallons) and the bottle volume.
To access the Bottle Setup Mode, the sampler must be in standby state, the
program cannot be in progress or "running". The sampler is in standby state
when the display indicated any one of the following: "Ready to Start",
"Program Complete", or "Program Halted". If the display reads "Program
Running", press the
CHANGE/HALT
placing the sensor in the "Program Halted" standby state.
1. With the sampler in standby state, press the * key. The display will read
"Enter units for bottle volume, milliliters?".
2. Press to cause other volume units to appear. When the desired units
NO
appear on the display, press
3. The display will show
Gallons , whichever was chosen in the previous step.
")
4. Enter the volume for the individual sample bottle by pressing the
numerical keys.
5. Press to accept the volume.
YES
This completes the bottle setup entries and the sampler is ready to program.
TIME/SET
. This will cause the minutes
YES
. This will cause the other indicator
NO
. Pressing
" YES
.
"
key. This will halt the program, thus
.
YES
Volume = _ _ _ _ _ mL (or "Volume = _ _ _ _ _
" "
Section 4
. The
TIME/READ
. The time and date will
. The
YES
. If the desired
YES
will start the clock. The
Page 23
Setting the Time and Date