Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
Page 2
Seller’s obligation under this warranty is limited to the one year from the date of original installation or 18 months repair of defects without charge by a Wells Mfg. Co. factory from the date of shipment from our factory, whichever...
PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Manufacturing Co. appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
FEATURES & OPERATING CONTROLS A. THERMOSTAT 1. On THERMOSTATICALLY CONTROLLED warmers, power is applied to the heating element according to the control knob position and the actual temperature at the temperature sensing thermobulb. 2. The desired temperature is controlled by rotating the TEMPERATURE CONTROL KNOB.
Do not operate this appliance if the control panel is damaged. Call instructions are read and your Authorized Wells Service Agent for service. followed. Damage to the The technical content of this manual, including any wiring diagrams,...
INSTALLATION NOTE: DO NOT discard UNPACKING & INSPECTION the carton or other packing Carefully remove the appliance from the carton. Remove all materials until you have protective plastic film, packing materials and accessories from the inspected the appliance for Appliance before connecting electrical power or otherwise performing hidden damage and tested it any installation procedure.
CAUTION: c. Wells Manufacturing recommends operating WET for consistent food heating. Electrical Shock d. If your wet-operation warmer is allowed to run dry, turn it...
HAZARD causing a potential fire and/or electric shock hazard. Contact your Authorized Wells Service Agency to inspect warmer if water or DO NOT submerge warmer grease contamination is suspected.
Page 9
Weekly, or whenever lime or scale is seen water for 15 minutes and accumulating on the sides of the warmer pans. consult a physician TOOLS: Wells Delime Cleaner (1 package per pan) SKIN: Wash with soap and Plastic Scouring Pad water Clean Cloth or Sponge INHALATION: Relocate to 1.
Warmer will not heat Temperature control not set Set control to desired temperature Internal damage Contact you Authorized Wells Ser- vice Agency for repairs Warmer trips circuit breaker Pan leaking or other internal Contact your Authorized Wells damage...
Never use metal implements, wire brushes, abrasive scratch pads or steel wool to clean stainless steel. Warmer pans, insets and other vessels are subject to a harsher environment. Wells Manufacturing uses an very high quality stainless steel (#304DDQ) for our food warmer pans.
ADAPTER TOP, convert SMPT, HW/SMP or 1 side of TMPT to hold one 11 qt. and one 7 qt. inset 21621 ADAPTER TOP, convert SW-10T from 11 qt. inset to 4 qt. inset 20822 ADAPTER TOP, convert SW-10T from 11 qt. inset to 7 qt. inset 20175 2½...
21109 service, or to order factory *LEGS, 2” Plastic, set of 4 20605 authorized replacement parts, contact your Wells LEGS, 4” Plastic Adjustable, set of 4 20314 authorized service agency, or call: LEGS, 4” Nickel Plated Alloy, Adjustable, set of 4 20563 DELIME CLEANER (Case of 24 7 oz.
Page 14
Wells Manufacturing proudly supports CFESA Commercial Food Equipment Service Association WELLS MANUFACTURING COMPANY DIVISION OF CARRIER REFRIGERATION 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 www.wellsbloomfield.com...