9.3
Vibrator
The bar-coded parameter menu and configuration software (ScannerSetting) provide three configuration choices:
indicating successful scanning (OK), indicating an error (NG), and disabled.
"OK" vibrations: The vibrator operates to indicate any of the following OK conditions.
• Successful transmission of the bar code data just read
• In data verification mode, successful registration of master data
• In the data verification mode, a match between the bar code data just read and master data registered
• End of data transmission started by the retransfer or specific character transfer function
• Scanning of "Start setting," "End setting," or parameter setting bar code from the bar-coded parameter menu
(Chapter 12)
• Start or end of parameter setting with the configuration software (ScannerSetting)
• Scanning of a batch-process bar code symbol generated with the configuration software (ScannerSetting)
"NG" vibrations: The vibrator operates to indicate any of the following failure conditions.
•- Wrong check digit(s) with check digits enabled
• Wrong number of digits in data for new master data registration
• In data verification mode, a mismatch between the bar code data just read and master data registered
• Editing error in the specified data editing, resulting in no transfer
• No ACK response received in the ACK/NAK mode
Note: It is recommended that the vibrator be disabled when the scanner is stationary to a stand.
32