Accessory Side Shelves Installation Instructions; Optional Stone Inlay Installation Instructions - Empire Comfort Systems VFP30CA30 Series Installation Instructions And Owner's Manual

accessoRY siDe sHeLVes instaLLation instRUctions

Installing Accessory Side Shelves:
1. Remove cast iron or stone inlay inserts from casting top and
carefully set them aside.
2. Remove cast iron top from stove and place upside down on a
flat, soft smooth surface to avoid damage.
3. Remove (4) ¼-20 hex head bolts from the outer edges of cast
iron top.
4. Place left and right side shelves in place shown in Figure 19.
5. Replace (4) ¼-20 hex head bolts to attach side shelves to
cast iron top, be sure shelf is tight to casting top before fully
tightening bolts.
6. Remove (8) ¼-20 hex head bolts from side shelves.
7. Replace cast iron top on unit.

OPTIONAL STONE INLAy INSTALLATION INSTRUCTIONS

Installation of Optional Stone Inlay
1. Remove left cast iron insert and right cast iron insert from
casting top.
Page 24
Figure 19
Figure 20
8. Attach side shelf supports one at a time, using (2) ¼-20 hex
head bolts per support, sliding support flush to casting before
fully tightening bolts as shown in Figure 20.
9. Replace cast iron or stone inlay inserts into casting top.
Note: Be sure to remove side shelf supports prior to removing
cast iron top to eliminate potential scratching or chipping to the
cast iron sides.
Note: Due to inherent properties of the casting process, non-com-
bustible shims may be required to level accessory side shelves to
the casting top. These shims are provided in the form of washers
to be used on either side of the bolts. See Figure 19. If accessory
shelf angles downward, toward the floor, washer(s) will need to be
added to the center side of the bolt. Conversley, if the accessory
side shelf angles upward, toward the ceiling, washer(s) will need
to be added to the outside of the top casting side of the bolt. See
Figure 22.
BOTTOM VIEW
BOTTOM VIEW
2. Insert left stone inlay and right stone inlay into casting top.
3. Installation of stone inlay is completed.
Figure 21
WASHER PLACEMENT
(OUTSIDE OF TOP
CASTING SIDE BOLT)
WASHER PLACEMENT
(CENTER SIDE OF BOLT)
Figure 22
26563-0-0410