Adjusting Air Shutter - Empire Comfort Systems VFP30CA30 Series Installation Instructions And Owner's Manual

The air shutter has been factory set to the optimum performance
level for this appliance. LP air shutter is not adjustable.
1. Remove cast iron top and carefully set aside.
2. Remove cast iron front and carefully set aside.
3. Remove screen door by removing two (2) screws. See Figure
5.
4. Carefully remove logs and set aside.
5. Remove the log shelf by removing the two (2) screws securing
the log shelf to the rear wall. See Figure 6.
6. Remove the burner by removing the two (2) screws at the front
of the burner as shown in Figure 7.
7. Carefully remove the burner by lifting straight up.
8. Loosen the two (2) nuts on the air shutter shown in Figure 8 to
adjust the air shutter. Figure 8 call-out demonstrates the proper
locations for Natural Gas. LP utilizes a fixed air shutter.
9. Tighten the two (2) nuts back down locking the air shutter in
place. Be sure that the air shutter is the same distance from
the burner orifice on both sides of the air shutter for proper
burner fit up.
10. Carefully replace the burner by dropping it down over the
orifice holder and air shutter lining up the front mounting holes
with the holes on the firebox.
11. Replace the two (2) screws at the front of the burner shown in
Figure 7.
12. Replace the log shelf by replacing the two (2) screws removed
in Step 4 securing the log shelf to the rear wall.
13. Replace Logs. See Page 11.
14. Replace the screen door by replacing the two (2) screws re-
moved in Step 3.
15. Replace cast iron front.
16. Replace cast iron top.
Note: Be sure air shutter is adjusted and tightened evenly to
ensure proper fit, failure to evenly adjust air shutter can cause
improper combustion. Only a certified technician should adjust
the air shutter.
Page 10

aDJUsting aiR sHUtteR

Figure 5
Figure 6
Figure 7
LOOSEN (2) NUTS
Figure 8
DIM. "A"
NAT 5/16"
3/4"
LPG
26563-0-0410