Log Placement - Empire Comfort Systems VFP30CA30 Series Installation Instructions And Owner's Manual

1. Remove cast iron top and carefully set aside.
2. Remove cast iron front and carefully set aside.
3. Remove two (2) screws from screen frame assembly.
4. Carefully remove screen frame assembly and set aside.
5. Remove logs from shipping crate. Remove all protective
packaging from logs and interior of firebox.
6. Place rear log onto two (2) pins on rear log support.
7. Place center left front log onto flat portion of left side of
burner.
8. Place right front log onto flat portion on right side of burner. Toe
of right front log should rest in groove on ember bed twig.
9. Place front left log chunk onto flat portion of burner on left
front side.
10. Place left twig onto left side pin on rear log with toe resting
on the groove in the left front log.
11. Place right twig onto right side pin on rear log with toe resting
all the way to the right on the right front log.
12. Align and place screen frame assembly over outer frame of
firebox.
13. Attach two (2) screws removed in step 3.
14. Log placement is completed.
15. Install cast iron front.
16. Install cast iron top.
Refer to Figure 9 for the following warning.
Warning: Failure to position the parts in accordance with
this diagram or failure to use only parts specifically approved
with this appliance may result in property damage or personal
injury.
LEFT TWIG
FRONT LEFT
LOG CHUNK CENTER
LEFT LOG
Log Placement - Top View
26563-0-0410

Log PLaceMent

RIGHT TWIG
REAR LOG
FRONT
RIGHT LOG
LEFT TWIG
REAR LOG
CENTER
LEFT LOG
FRONT LEFT
LOG CHUNK
Figure 9
REAR LOG
LEFT TWIG
CENTER
FRONT LEFT
LEFT LOG
LOG CHUNK
Log Placement - Front View
RIGHT TWIG
FRONT
RIGHT LOG
BURNER TOP
RIGHT TWIG
FRONT
RIGHT LOG
Page 11