Runco Reflection VX-3c Owner's Operating Manual page 84

STEP 4!"Pull lens assembly out
! See Figure 4.13. Carefully pull the lens
assembly straight out of the projector and set
aside.
STEP 5! Install new lens assembly
! IMPORTANT: Remove the rear (smallest)
lens cap from the new lens. Make sure the front
lens cap remains on during installation.
! See Figure 4.14. Align the large cut-out area
on the lens flange to the bottom of the lens
mount (which has a matching cut-out). The 3
lens assembly slots should align with the lens
mount screws so that the screw heads will fit
through the large end of the slots.
NOTE: On most lenses, a small extra "keying"
slot located at approximately 2 o'clock on the
lens flange will align with a set screw in the
same location on the lens mount, preventing the
lens from being installed in the wrong orienta-
tion. If the lens flange does not seem to fit into
place over all screws, try rotating the lens assembly in one direction or another.
Figure 4.13. Remove lens assembly
Figure 4.14. Orientation
4-7
MAINTENANCE