Table of Contents
Advertisement
INSTALLATION AND SETUP
S-Video!
The video decoder input panel provides simultaneous connection of both a composite video
source (INPUT 3) and an S-Video source (INPUT 4).
If connecting an S-Video source, use the 4-pin mini DIN connector or the Y and C BNC con-
nectors (luma and chroma) at INPUT 4-do not use both as inputs. See Figure 2.14.
Figure 2.14. Connecting S-Video
AUDIO for INPUT 4: To control audio levels in an audio/visual system, connect pre-amplified
(line level) audio inputs to the "IN 4" left and right channel audio inputs located near the top left
corner of the rear input panel. Then connect external audio amplification equipment to audio
"OUT" for sound output. Audio connection cables require standard RCA type phono plugs.
NOTE: If you want to loop an S-video signal through to another projector or display device, see
Video Loop Through below.
2-15
Advertisement
Table of Contents
