Care And Maintenance; Tire Pressure; Wheel Replacement; Exterior Surfaces - Pride Mobility Go-Go Ultra X Owner's Manual

X . C A R E A N D M A I N T E N A N C E
Your Travel Scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability
to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Pride
Provider. The following areas require periodic inspection and/or care and maintenance.

TIRE PRESSURE

If equipped with pneumatic tires, always maintain a proper 30-35 psi tire pressure.
WARNING! It is important that 30-35 psi tire pressure be maintained in pneumatic tires at
all times. Do not underinflate or overinflate your tires. Low pressure may result in loss of
control, and overinflated tires may burst. Failure to maintain 30-35 psi tire pressure in
pneumatic tires at all times may result in tire and/or wheel failure, causing serious personal
injury and/or damage to your Travel Scooter.
Regularly inspect your Travel Scooter's tires for signs of wear.

WHEEL REPLACEMENT

If your Travel Scooter is equipped with pneumatic tires and you have a flat tire, you can have the tube replaced. If your
Travel Scooter is equipped with a solid tire insert, either the solid insert or the entire wheel must be replaced depending
on model. Contact your authorized Pride Provider for information regarding replacement wheels for your Travel Scooter.
WARNING! Prevent personal injury! Completely deflate pneumatic tyres before dismantling
the rim or attempting repair.
WARNING! When changing a tire, remove only the center lug nut, then remove the tire. If
any further disassembly is required, deflate the tire completely or it may explode, possibly
resulting in personal injury.

EXTERIOR SURFACES

Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the Travel Scooter's vinyl seat or tire
tread. They will become dangerously slippery and result in personal injury and/or damage
to your Travel Scooter.
CLEANING AND DISINFECTION
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your scooter. Avoid
using products that may scratch the surface of your scooter.
If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Prevent personal injury and product damage! Follow all safety instructions for
the proper use of the disinfectant before applying it to your product.
WIRING HARNESSES
Regularly check all wiring connections.
Regularly check all wiring insulation, including the charger power cord, for wear or damage.
Have your authorized Pride Provider repair or replace any damaged connector, connection or insulation that
you find before using your Travel Scooter again.
34
www.pridemobility.com Go-Go Ultra X