Connecting Cables To The Computer; Operation Of The Monitor; Adjusting Rake - Fujitsu Siemens Computers SCENICVIEW B15-1A Operating Manual

Connecting cables to the computer

Information on the computer connections and interfaces is contained in the operating manual for
your computer.
If your computer has two monitor ports ("onboard" screen controller and separate
i
graphics card), the monitor port for the separate graphics card is usually active.
► Connect the data cable to the (active) monitor port on the computer and secure the plug-in
connection by tightening the safety screws.
► Insert the other plug of the audio line in the audio output of the computer.
► Connect the connector of the power cable supplied into a properly grounded mains outlet and
ensure a secure connection.
► Plug the power connector of the computer into a properly grounded mains outlet.
When you start working with your monitor for the first time you should install the
i
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your screen controller/the associated driver software.

Operation of the monitor

The monitor offers the following possibilities that enable it to be optimally adjusted for the respective
user and the respective situation.

Adjusting rake

The rake of the monitor can be adjusted by -5° (forward) and +20° (back) from its vertical position.
► Grasp the monitor with both hands on the right and left edge of the casing and adjust it to the
desired rake.
A26361-K938-Z100-2-5E19
Colour monitor SCENICVIEW B15-1A
English - 11