Connecting The Monitor; Connecting Cables To The Monitor - Fujitsu Siemens Computers SCENICVIEW B15-1A Operating Manual

Colour monitor SCENICVIEW B15-1A

Connecting the monitor

Observe the "Safety notes" in the "Important notes" chapter in this operating manual.
!
CE conformance and optimum picture quality are guaranteed only if you use the data
cable supplied.
Do not cover the ventilation openings of the monitor.
The computer power plug must be pulled out!
► Be sure that the monitor and the computer are switched off.

Connecting cables to the monitor

The monitor ports are protected by a cover. The cover is not attached on delivery.
6
The data cable supplied has two 15-pin D-SUB connectors for connection to the monitor and to the
computer.
► Connect one of the connectors of the data cable to the D-SUB connector on the monitor (5) and
secure the plug-in connection by tightening the safety screws.
► Insert one plug of the audio line in the AUDIO IN (3) socket on the monitor and make sure it is
properly engaged.
► Plug the power cable supplied into the power connector (6) of the monitor.
► Mount the cover over the connections (1).
A lock (Kensington Lock) can be mounted in the security slot (2) to protect the monitor
i
from theft. A Kensington Lock is not included in the consignment of the monitor.
10 - English
1
4 3 2
5
1 = Cover position
2 = Security slot for "Kensington Lock"
3 = AUDIO-IN connector
4 = Headphones port
5 = D-SUB connector (ANALOG)
6 = Power connector
A26361-K938-Z100-2-5E19