Viewing System Log; Viewing System Parameters; Factory Default - LevelOne FCS-1040 User Manual & Spare Parts Catalogue

Viewing System Log

Click on the link on the configuration page to view the system log file. The content of the file
provides useful information about configuration and connections after system boot-up.

Viewing System Parameters

Click on this link on the configuration page to view the entire system's parameter set. The content
is the same as those in CONFIG.INI.

Factory Default

"Factory default"
Click on this link on the configuration page to restore factory default settings. Any changes made
so far will be lost and the system will be reset to the initial factory settings. After clicking on the
"Restore" button and make confirmation, the system will restart and require the installer program
to set up the network again.
"Calibrate"
Recalibrate the home position to the default center to recover the tolerance caused by some external forces. Please
note that there is no confirming message box after clicking on the "Calibrate" button, the Network Camera will calibrate
immediately.