Camera Control - LevelOne FCS-1040 User Manual & Spare Parts Catalogue

Camera Control

On the Camera Control page, there are two main function control areas:
Camera control area
The pan and tilt functions can be controlled with these buttons. The "Left" button aims the camera
to the left; the "Right", "Up", and "Down" buttons aim the camera accordingly. The "Home" button
aims the camera to the center.
"-" and "+" buttons beside "Zoom" control the zoom widely function and zoom telescopically.
"-", "Focus" and "+" in the same row control the focus near function, auto focus function and focus
far function.
"-", "IRIS" and "+" in the same row set the aperture smaller, auto-IRIS and set aperture bigger.
"Pan speed" This controls the range of the horizontal movement of the camera. The greater the
value, the greater angular movement when performing the "Left" or "Right" functions.
"Tilt speed" This controls the range of the vertical movement of the camera. The greater value,
the greater angular movement when performing the "Up" or "Down" functions.
"Zoom speed" This controls the range of the zooming. The greater the value, the greater
viewing angle changed.
"Focus speed" This controls the range of the focus adjustment. The greater the value, the
greater adjustment.
"Auto pan/patrol speed" This defines the speed of panning and patrol, the greater the value,
the faster the speed.
Preset function area
"Current position" If the User wants to save the current view as a preset location, enters a name
for each of the current video view at "Current position" and click on the "Add" button. The camera
allows for ten preset locations.
* The preset function is valid only in optical zoom mode.
"Preset position" This keeps a list for preset positions. Clicking on the "Delete" button will
remove the current selected position from the preset list.
"Set as home" Click on the button will command the Network Camera to set the current aiming
position as Home position. That is: when user click on the "Home" control in Camera control area
or after the Network Camera rebooted, the aiming area will be moved to the current position.
"Default home" Click on the button will restore the "Home" definition to the original position.
"Dwelling time" The value set here specifies:
1. The stop time of each preset location during auto patrol of the Network Camera.
2. The stay time at the most left and the most right positions when the Network Camera is doing
auto panning.
"Enable IR control" Checking this box allows the Administrator to enable the IR controller to