Application Setup - LevelOne FCS-1040 User Manual & Spare Parts Catalogue

Application Setup

Weekly Schedule
"Sun" ~ "Sat" Select the days of the week to perform the following operations.
"Snapshots begin at" Set the time to start operations.
"Snapshots stop at" Set the time to stop operations. Setting identical begin time and stop time
means 24-hour operation.
"All the time except for the above schedule" Invert the selected schedule. The default setting of
this option is checked.
"Snapshot file name prefix" Specify the prefix name for the snapshot file. For example, if the
prefix name of the snapshot file is "LevelOne", the snapshot file name will be LevelOne
_20041116105638.jpg, that means the snapshot is taken at 10:56:38, 2004/11/16.
Event Operation
"Delay second(s) before detecting next event" Set the time delay before restarting to check on
the triggering condition when the current condition is triggered.
"Send pre-event image(s) when event occurs" Specify how many pre-event snapshot will be
sent if events happen.
"Trigger condition" There are four conditions relative to the digital input and three windows for
motion detection. More than one condition can be selected at once. Select the appropriate digital
input condition that suits the characteristics of the external device. "high", "low" selects
level-triggering via external voltage input. "rising", "falling" is for edge-triggering. There are three
windows for motion detection each can be assigned a name. If motion detection has not been set
up, it will not be shown. If this happens, clicking on "Motion detection" and a note will show to
direct the User to the configuration page for motion detection.
"Trigger action" There are four options for two types of action. More than one condition can be
selected at once. While choosing to trigger an output alarm, the digital output will short both pins
and complete the external device's circuit. The normal state is open. Either email or FTP can be
used to command uploading snapshots. The snapshot names will be "videopre.jpg", "videotrg.jpg",
and "videopos.jpg", respectively. They stand for the snapshots, before event, right upon event,
and after event. The date and time suffix may also be added as an option. Confirm the external
mail or FTP server settings in the network configuration.
"Reset output" Select and save this option to reset the external device at the digital output to
return to the original state.