Pentax K-5II Operating Manual page 88

86
2
Press the four-way controller (5)
and use the four-way controller
(23) to select [Auto], [Off],
[Low], [Medium], [High] or
[Custom].
Auto
Off
Low/Medium/
High
4
Custom
3
Press the 4 button.
If you select [Auto], [Off], [Low], [Medium], or [High], proceed to Step 7.
4
Use the four-way controller (23) to select [Setting] and
press the four-way controller (5).
The screen to set the noise reduction level according to the sensitivity appears.
5
Use the four-way controller (23)
to select a sensitivity value and use
the four-way controller (45) to set
the level of noise reduction which is
applied to the selected sensitivity.
Turn the rear e-dial (S) to display the
[High-ISO NR 2] screen.
Press the | button to reset the setting of
the selected sensitivity value.
The sensitivity values displayed vary according to the [1. EV Steps] and [2.
Sensitivity Steps] settings made in the [A Custom Setting 1] menu.
6
Press the 3 button.
The screen that was displayed in Step 2 appears again.
7
Press the 3 button twice.
The camera is ready to take a picture.
Applies Noise Reduction at optimally calculated levels
throughout ISO range. (default setting)
Does not apply Noise Reduction at any ISO setting.
Applies Noise Reduction at constant chosen level
throughout ISO range.
Applies Noise Reduction at user-defined levels for each ISO setting.
High-ISO NR
ISO
Auto
AUTO
NR
ISO
Off
OFF
NR
ISO
Low
NR
ISO
Medium
NR
ISO
High
NR
ISO
Custom
CUSTOM
NR
MENU Cancel
High-ISO NR
ISO 80
ISO 100
ISO 200
ISO 400
ISO 800
ISO 1600
ISO 3200
MENU
OK OK
1 2
ISO
OFF
NR
ISO
OFF
NR
ISO
OFF
NR
ISO
OFF
NR
ISO
NR
ISO
NR
ISO
NR
Reset