Flash Units - Pentax K-5II Operating Manual

172
Changing the Built-in Flash Discharge Method
You can change the built-in flash discharge method used in wireless
mode.
Set in [21. Flash in Wireless Mode] of the [A Custom Setting 3]
menu.
1
2
HSb (High-speed flash sync) is not available with the built-in flash.
Wireless Shooting Using a Combination of External

Flash Units

5
1
Set the wireless mode of the external flash directly
connected to the camera to [MASTER] or [CONTROL].
MASTER
CONTROL
2
On the wireless remote flash unit, set the wireless flash
mode to [SLAVE] and set the channel to the same channel
as the flash directly connected to the camera. Then, place
it at the desired location.
3
Confirm that both flashes are fully charged and then take
a picture.
• The Shake Reduction function is automatically turned off in wireless mode.
• When using multiple AF540FGZ/AF360FGZ external flashes and performing
high-speed flash sync shooting in wireless mode, set the flash directly
connected to the camera to high-speed flash sync mode.
• When the wireless mode of the external flash directly connected to the
camera is set to [MASTER] or [21. Flash in Wireless Mode] (p.172) is set to
[On] for the built-in flash, all the flashes will discharge simultaneously.
On Discharges the built-in flash as a master. (default setting)
Off Discharges the built-in flash as a control flash.
Discharges both the flash directly connected to the
camera and the wireless flash unit as the main flash.
Discharges the flash directly connected to the camera as
a control flash only, not as the main flash.