Table - Grizzly H6246 Instruction Manual

Table

Components and Hardware Needed:
Sliding Table ...................................................... 1
Table Brace ....................................................... 1
Cover Plate ........................................................ 1
Cap Screws M6-1 x 20 ...................................... 2
Hex Nuts M6-1 .................................................. 4
Hex Bolts M6-1 x 8 ............................................ 4
Flat Washers 6mm ............................................ 4
Front Rail (w/Groove for Bearing) ..................... 1
Rear Rail ........................................................... 1
Carriage Bolts M6-1 x 12 ................................... 4
Acorn Nuts M6-1 ............................................... 4
Tools Needed:
Wrench or Socket 10mm ................................... 2
To install the table:
1. Place the cover plate on the saw unit as
shown in Figure 11.
Figure 11. Cover plate in the correct position
with holes aligned.
-16-
2.
Place the rear rail over the cover plate and
align the mounting holes.
3. Secure the rear rail and cover plate to the
Qty
saw body with two carriage bolts and acorn
nuts. Note—The acorn nuts are meant to be
mounted outside of the saw body, as shown
in Figure 12.
Qty
Figure 12. Rear rail attached to saw body.
4. Install the front rail in the same manner as the
rear rail.
5.
Slide the table onto the rails so the table roll-
ers roll freely along the rails.
6. Standing at the back of the saw, push the
table forward as far as it will go.
7.
Install the table brace on the back of the
table, up underneath the table lip, and secure
it with the four hex bolts and flat washers
(Figure 13).
H6246 Meat Cutting Bandsaw