Table of Contents
Advertisement
Fences
Components and Hardware Needed:
Long Fence ....................................................... 1
Short Rail ........................................................... 1
Short Fence ....................................................... 1
Long Rail ........................................................... 1
Knob Bolts M8-1.25 x 20 ................................... 2
Set Screws M8-1.25 x 12 ................................... 2
Hex Bolts M6-1 x 16 .......................................... 4
Rail Brackets ..................................................... 2
Tools Needed:
Wrench or Socket 10mm ................................... 1
To assemble fence:
1.
Mount the two rail brackets to the edge of the
table with the hex bolts, as shown in Figure
16.
Figure 16. Rail brackets installed on table.
2.
Insert the end of the long rail into the short
fence and secure together with one of the set
screws (Figure 17).
3.
Insert the end of the short rail into the long
fence and secure together with the remaining
set screw.
-18-
Qty
Qty
Figure 17. Securing fence to rail.
4.
Slide the long rail/short fence assembly into
the bracket that is mounted on the front of the
table.
5.
Slide the short rail/long fence assembly into
the bracket that is mounted on the left-side of
the table.
6.
Use the knob bolts to tighten both fence
rails to the fence brackets. Your completed
assembly should look like Figure 18.
Figure 18. Completed assembly of fences and
rails.
H6246 Meat Cutting Bandsaw
Advertisement
Table of Contents
