Service Checklist-Diagnosis Guide; General Maintenance - Spirit F7600 Instruction And User's Manual

make sure the belt stays in the middle of the deck. If the belt tracks to one side then follow the belt
tracking instructions to remedy. Now the deck is lubricated and you should walk,
not run, on the treadmill immediately for at least 5 minutes to ensure the lubricant is evenly
distributed. If you purchase a silicone based Lube-N-Walk kit, follow the instructions that come with
it to apply the lubrication.
SERVICE CHECKLIST – DIAGNOSIS GUIDE
Before contacting your dealer for aid, please review the following information. It may save you
both time and expense. This list includes common problems that may not be covered under the
treadmill's warranty.
PROBLEM
Display does not light
Tread-belt does not stay centered
Treadmill belt hesitates when
walked/run on
Motor is not responsive after
pressing start
Treadmill will only achieve
approximately 7 mph but shows
higher speed on display
Tread-belt stops quickly/suddenly
when tether cord is pulled
Treadmill trips on board 15 amp
circuit
Computer shuts off when console is
touched (on a cold day) while
walking/running
House circuit breaker trips, but not
the treadmill circuit breaker
SOLUTION/CAUSE
1.Tether cord not in position.
2.Circuit breaker on front grill tripped.
Push circuit breaker in until it locks.
3.Plug is disconnected. Make sure plug is firmly pushed into
AC household wall outlet.
4. Household circuit breaker may be tripped.
5. Treadmill defect. Contact your dealer.
The user may be walking while favoring or putting more
weight on either the left or right foot. If this walking pattern is
natural, track the belt slightly
Off-center to the side opposite from the belt
movement. See General Maintenance section on
Tread-belt Tension Adjust as necessary.
If the belt moves, but stops after a short time and thedisplay
shows "LS", run calibration.
If you press start and the belt never moves, then
the display shows LS, contact service.
This indicates motor should be receiving power to
operate. Low AC voltage to treadmill. Do not use an
extension cord. If an extension cord is required it
should be as short as possible and heavy duty 16
gauge minimum. Low household voltage. Contact an
electrician or your dealer. A minimum of 220V
AC current is required.
High belt/deck friction. See General Maintenance
section on lubrication.
High belt/deck friction. See General Maintenance
Treadmill may not be grounded. Static electricity is
crashing" the computer. Refer to Grounding.
Need to replace the house breaker with a "High In-
rush current" type breaker.
10155
page-27