Service Checklist - Diagnosis Guide - Spirit CT900 ENT Owner's Manual

SERVICE CHECKLIST - DIAGNOSIS GUIDE

Before contacting your dealer for aid, please review the following information. It may save
you both time and expense. This list includes common problems that may not be covered
under the treadmill's warranty.
PROBLEM
Display does not light
Treadbelt does not stay centered
Treadmill belt hesitates when walked/run on
Motor is not responsive after pressing start
Treadmill will only achieve approximately 7mph
but shows higher speed on display
Treadmill trips on board 20 amp circuit
Computer shuts off when console is
touched (on a cold day) while walking/running
Circuit breaker trips, but not the
treadmill circuit breaker.
Dyaco Canada Inc. 2018 customerservice@dyaco.ca
SOLUTION/CAUSE
1) Tether cord not in position.
2) Circuit breaker on front grill tripped. Push circuit breaker
in until it locks.
3) Plug is disconnected. Make sure plug is firmly pushed
into 120 VAC wall outlet.
4) Breaker panel circuit breaker may be tripped.
5) Treadmill defect. Contact your dealer.
The user may be walking while favoring or putting more
weight on either the left or right foot. If this walking pattern
is natural, track the belt slightly off-center to the side
opposite from the belt movement.
See General Maintenance section on Treadbelt Tension.
Adjust as necessary.
1. Reset power. If still no good contact service.
This indicates motor should be receiving power to
operate. Do not use an extension cord. If an extension
cord is required it should be as short as possible and
heavy duty 16-gauge minimum, low voltage. Contact an
electrician or your dealer. A minimum of 120 volt AC
current is required.
High belt/ deck friction. See General Maintenance section
on cleaning the deck. If cleaning doesn't prevent this
from reoccurring, check to see if there is significant wear of
the deck. If so, the deck may need to be flipped if it is on its
original side.
Treadmill may not be grounded. Static electricity is
"crashing" the computer. Refer to Grounding Instructions
Need to replace the breaker with a "High
inrush current" type breaker
46