Aligning Table To Blade - Grizzly G0668 Owner's Manual

table alignment
��������
Aligning Table to
Blade
To ensure the angle accuracy of the cut, the table
must be 90° to the blade from front-to-back and
side-to-side. If the table is not square to the blade,
it needs to be adjusted.
Tools Needed:
Hex Wrench 5mm .............................................. 1
Wrench 12mm ................................................... 1
To adjust the table square to the blade:
1.
DISCONNECT BANDSAW FROM POWER!
2.
Make sure the wheels are correctly aligned
(Page 38) and the blade is properly ten-
sioned (Page 25).
3. Set the angle of the table to "0".
-40-
�������������
��������
Figure 49. Examples of wheel orientation to one another.
Qty
������������
������������
4.
Use a square to check table alignment with
the side and the back of the blade, as shown
in Figure 50.
Figure 50. Checking table alignment with the
blade.
G0668 20" Vertical Metal-Cutting Bandsaw
����������
������������