Table of Contents
Advertisement
Adjusting
Downfeed Stop Bolt
If the blade does not travel far enough to complete
the cut, or the blade contacts the vise table, then
the downfeed stop bolt will need to be adjusted.
Tools Needed
Open-Ended Wrench 19mm .............................. 1
To adjust downfeed stop bolt:
1.
DISCONNECT MACHINE FROM POWER!
2.
Lower headstock all the way.
— If blade is just below vise table, but not
contacting it, no adjustment is required.
— If blade contacts vise table, proceed to
Step 3.
— If blade is above vise table, proceed to
Step 4.
3.
Raise headstock until blade is just below vise
table surface and adjust downfeed stop bolt
and nut to secure headstock position (see
Figure 55). Adjustment is complete.
4.
Adjust downfeed stop bolt until blade is just
below vise table, but not contacting it (see
Figure 55). Tighten jam nut to secure.
Downfeed
Stop Bolt
Figure 55. Location of downfeed stop bolt.
-42-
Qty
Jam Nut
Squaring Blade to
Table
It is always a good idea during the life of your saw
to check and adjust this setting. This adjustment
will improve your cutting results and extend the
life of your blade.
Tools Needed
Machinist's Square ............................................ 1
Wrench or Socket 13mm ................................... 1
To square blade to table:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen blade guide adjustment knob, slide
guide as far from front guide as possible, and
then tighten knob.
3.
Lower headstock until it contacts downfeed
stop bolt (see Figure 56).
Downfeed
Stop Bolt
Figure 56. Location of downfeed stop bolt.
Model G0926 (Mfd. Since 11/20)
Qty
Advertisement
Table of Contents
