Pentax Q10 Operating Manual page 123

2
Use the four-way controller (45)
to select the white balance.
When J (Fluorescent Light) is selected,
press the four-way controller (3) and use
the four-way controller (45) to select D,
N, W, or L.
Proceed to Step 6 if you do not need to
change the parameters.
3
Press the mc button.
The fine-tuning screen appears.
4
Fine-tune the white balance.
Available operations
Four-way controller
(23)
Four-way controller
(45)
d/i button
5
Press the 4 button.
The screen that was displayed in Step 2 appears again.
6
Press the 4 button.
The camera is ready to take a picture.
Because the light source changes when a flash discharges, you can set the
white balance for when the flash discharges. Select [Auto White Balance],
[Unchanged] or [Flash] in [5. WB When Using Flash] of the [A Custom Setting
1] menu.
Adjusts the tone of the colors between green (G) and
magenta (M).
Adjusts the tone of the colors between blue (B) and
amber (A).
Resets the adjustment value.
Auto White Balance Auto White Balance
Cancel Cancel
MENU WB± WB±
G3 G3 A2 A2
SHUTTER Adjust Adjust
Cancel Cancel ±0 ±0
MENU
121
OK OK
OK
5
OK OK
OK