Wells WATER-MAX Owner's Manual page 41

DISPENSER TANK
A. Tank Disassembly (refer to page 25)
1. Carefully drain all water from the tank. Remove the tank from
Water-Max™. Remove the tank lid from the tank and store in
a safe place.
2. Remove temperature gauge and holding nut from tank.
3. Disassemble faucet shank assembly (see page 38).
4. Remove four screws from side lips of reservoir assembly.
5. Lift tank reservoir assembly out of wrap.
6. Disconnect wiring as required.
B. Reassembly
1. Reconnect any wires disconnected during service.
2. Apply a thin bead of food-grade silicone sealant along the top
lip of the wrap.
3. Install tank reservoir into wrap. Be sure tank is properly
oriented.
4. Secure reservoir assembly into tank by installing four screws in
side lips.
5. Reinstall faucet assembly (see page 38).
6. Fill the tank with tap water. Check for leaks.
7. Empty the tank. Install the tank lid and reinstall tank on Water-
Max™.
TANK HEATER
1. Disassemble tank per above.
2. Using a putty knife or similar scraper, remove old heater
assembly and any remaining RTV from outside of tank.
3. Attach new heater assembly to bottom and front of tank.
Refer to Exploded View on page 25 for location.
4. Seal edges of heater using Hi-Temp (red) RTV sealant.
5. Allow to set for at least one hour, then reassemble tank as
detailed above.
SERVICING INSTRUCTIONS (continued)
Carefully empty water from tank
and remove tank from Water-
Max™ and before performing any
servicing.
TOOLS REQUIRED:
#2 Phillips Screwdriver
18" Adjustable Wrench
Container to hold fasteners
Teflon Thread Tape
Food-Grade Silicone Sealant
Note: Be careful to avoid
scraping, trapping or pinching
wires as the reservoir is lowered
into the wrap.
TOOLS REQUIRED:
#2 Phillips Screwdriver
18" Adjustable Wrench
Container to hold fasteners
Teflon Thread Tape
Food-Grade Silicone Sealant
Putty Knife
Hi-Temp (Red) RTV Sealant
39
CAUTION:
Burn Hazard