Using Water-Max - Wells WATER-MAX Owner's Manual

USING WATER-MAX™

Water-Max™ is used to dispense hot water for food preparation.
Set-Up and Usage
Install the water tank on the Water-Max™ shelf.
Make sure that the tank is properly positioned, that the connector is
seated and that the dispensing nozzle lowered into position in the water
tank lid.
Press the power switch to
water.
Status indicator will glow when the tank is filling.
Status indicator will go out when the tank is full.
Place an appropriate container under the faucet. Being careful to not
overflow the container, pull the faucet handle to dispense hot water.
Fig. 6 Water-Max™ Operation
To Keep Water in Tank Hot
Leave the power switch ON. Water-Max™ will maintain tank water
temperature at 202ºF minimum, and will be ready to dispense hot
water.
and allow the water tank to fill with hot
ON
Water-Max™ is designed to
operate with a matching 5 gal.
water tank only.
Do not hold anything other
than the matching water tank
under the dispensing nozzle.
Splashing hot water will cause
serious burns.
GENERAL GUIDELINES
NEVER hold or place
anything, other than the proper
tank, under the dispense
nozzle. Draw water only from
the hot water faucet of the
water tank.
NEVER attempt to remove or
carry a water tank while full of
water.
NEVER attempt to operate
Water-Max™ without the lid
properly installed on the water
tank.
Exposed surfaces can be hot
to the touch and may cause
burns.
IMPORTANT:
If water temperature will not
rise out of the RED zone,
Water-Max™ must be delimed.
See page 14.
11
OPERATION
WARNING:
BURN HAZARD
CAUTION:
Hot Surface