Table of Contents
Advertisement
SERVICING INSTRUCTIONS (continued)
TOOLS REQUIRED:
#2 Phillips Screwdriver
Container to hold fasteners
Note: Be careful to avoid
scraping, trapping or pinching
wires as the wrap is lowered
over the frame.
D. TOP COVER AND WRAP ASSEMBLY
Note: For the purpose of servicing Water-Max™, the top cover and
wrap may be removed as a unit.
1. Removal
a. Remove the tank shelf, support cover and front assembly.
(see A., B. and C., page 25).
b. Remove four screws (d) from the area beneath the shelf.
c. Remove screw (f) from power board support.
d. Loosen three chassis screws (e).
e. Remove three screws holding delime fitting retainer.
f.
Work the wrap off of the frame and delime fitting. Be aware of
wiring or connectors which may hang-up in the cooling louvers.
2. Installation
a. Work the wrap over the frame. Gently work the slot in the top
cover over the delime fitting. Delime retainer must be on top of
the wrap. The recessed side flanges of the lower cover must
be on the inside of the wrap.
b. Reinstall three screws a delime retainer, four screws (a) at top
of the wrap and four screws (d) in the area beneath the shelf.
28
Hide quick links:
Advertisement
Table of Contents
