Deliming Instructions - Wells WATER-MAX Owner's Manual

DELIMING INSTRUCTIONS

CAUTION:
BURN HAZARD
TM
Water in Water-Max is
EXTREMELY HOT!
TM
Deliming Water-Max
It is time to delime the Water-Max™ when:
•
The DELIME indicator light glows; or,.
•
The water nozzle temperature is consistently below 197°F.
1. Drain 1 GALLON from TANK.
•
Press POWER SWITCH to OFF.
•
Use plastic pitcher to drain 1 gallon from water tank. Dump
pitcher of water into sink.
•
Check the SOLUTION BOTTLE. If it is cracked or distorted,
replace it with a new bottle.
IMPORTANT: Delime with LIIMESHIELD
Soil Inhibitor only! (PCN 0021023) A graduated scoop is
provided in the LIMESHIELD container.
TM
2. Mix LIMESHIELD
•
Measure 1/2 cup (4 ounces) of hot tap
water. Pour this into the 1 gallon pitcher.
•
Measure 1/3 cup (2.5 ounces) of
LIMESHIELD powder is completely
dissolved.
•
When foaming stops, swirl solution to
insure the LIMESHIELD power is
completely dissolved.
3. Insert bottle in Water-Max
disconnect fitting.
•
Use the funnel provided with the Water-Max
solution into the solution bottle.
•
Screw quick-disconnect dispenser cap onto solution bottle.
Dispenser cap is chained to top of Water-Max
•
The quick-disconnect fitting is located on the left top of the
TM
Water-Max . Press the latch until it "clicks" open.
•
Turn the solution bottle over. Insert bottle quick-disconnect
fitting on the bottle into Water-Max
Press solution bottle down until the latch "clicks", lock the
solution bottle in place.
4. Squeeze solution into Water-Max
•
Squeeze solution bottle and force deliming solution into
Water-Max™ until empty.
5. Remove and rinse solution bottle.
•
Press latch on tank quick-disconnect fitting until it "clicks" to
release the solution bottle. Lift solution bottle straight up.
•
Unscrew quick-disconnect cap allowing solution bottle to return
to shape.
14
TM
Scale and Food
TM
quick-
TM
to pour the
TM
TM
quick-disconnect fitting.
TM
.
.