Step 6:
Cap the Press Support (20) with four 2" Sq
End Caps (60). Attach the Press Support
(20) to the sleeve on the Top Frame (7)
using one Pivot Axle (35). Secure the Pivot
Axle (35) by tightening the two 3/8" x 1/2"
Sunken Head Screws (91).
Cap the Press Arm (21) with two 2" Sq End
Plugs (60). Slide the 1-1/4" Hand Grips
(49) onto handle bars on the Press Arm
(21). If the Hand Grips (49) are difficult to
slide onto the Press Arm (21) try applying
a small amount of soapy water to the Press
Arm (21) prior to sliding on the grips.
Attach the Press Arm (21) to the Press
Support (20) using one Pivot Axle (35).
Secure the Pivot Axle (35) by tightening the
two 3/8" x 1/2" Sunken Head Screws (91).
-15-