Step 4:
Cap the Leg Curl Support (16) with one
2" Sq End Cap (60). Attach the Leg
Curl Support (16) to the Front Extension
(3) using two 1/2" x 3-1/4" Hex Head
Bolts (79), four 1/2" Washers (95) and
two 1/2" Nylon Nuts (99). Attach the
Leg Curl Support (16) to the Press
Upright (4) using two 3/8" x 4" Hex Head
Bolts (81), four 3/8" Washers (96) and
two 3/8" Nylon Nuts (100).
Cap the Leg Curl Seat Arm (17) with 2"
Sq End Plugs (60). Slide the 1" x 5-
1/2" Hand Grips (51) onto the Seat
Handle Bars (18). If the Hand Grips
(51) are difficult to slide onto the Handle
Bars (18) try applying a small amount
of soapy water to the Handle Bars (18)
prior to sliding on the grips. Attach the
Seat Handle Bars (18) to the Leg Curl
Seat Arm (17) using two 3/8" x 3" Hex
Head Bolts (83), four 3/8" Washers (96)
and two 3/8" Nylon Nuts (100). Insert
the Leg Curl Seat Arm (17) into the Leg
Curl Support (16) and lock with the
Quick Release (70).
-13-