Denon AVR-E300 Owner's Manual page 128

GAudioH
Symptom
Audio is not output. • Check the connections for all devices.
• Check the speaker connections and configurations.
• Check whether the audio device power is turned on.
• Adjust the master volume.
• Cancel the mute mode.
• Check the connection with the playback device and select the
proper input source.
• Match the input mode and the terminal assigned to be the digital
input terminal.
• Disconnect the headphones. No sound is output from the
speakers when headphones are connected.
The volume does not • The maximum volume is set too low. Set the maximum volume
increase. using "Limit"on the menu.
• Power for external devices connected to the output connectors
of the unit may not be turned on. Check the power of connected
external devices.
No sound is • Check if the surround speakers are connected to the SURROUND
produced from terminals.
surround speakers.
No sound is • Check the subwoofer connections.
produced from • Turn on the subwoofer's power.
subwoofer. • Set "Speaker Config." – "Subwoofer" on the menu to "Yes".
• If "Front" and "Center" for "Speaker Config." are set to "Large",
and "Subwoofer Mode" is set to "LFE", no sound may be output
from the subwoofers, depending on the input signal or selected
sound mode.
DTS sound is not • Set "Decode Mode" on the menu to "Auto" or "DTS".
output.
Dolby TrueHD, DTS- • Make HDMI connections.
HD, Dolby Digital
Plus audio is not
output.
DVD
Cause/Solution
9, 10, 13,
14, 15, 16,
17, 18, 19
Symptom
Page
Dolby PLg mode or • Check that "Speaker Config." – "Center" or "Surround" is set to
other than "None". If the speaker system is 2.0/2.1-channel, this
DTS NEO:6 mode
sound mode cannot be selected.
cannot be selected.
• When headphones are used, Dolby PLg or DTS NEO:6 cannot be
76 selected.
–
Audyssey MultEQ ® ,
• Switch the sound mode to other than "DIRECT".
28 • When headphones are used, Audyssey MultEQ ® , Audyssey
Audyssey Dynamic
28 EQ ® and Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® cannot be selected.
27 Dynamic Volume ®
cannot be selected.
97
• Run Audyssey ® Setup.
Audyssey Dynamic
EQ ® and Audyssey
112
Dynamic Volume ®
cannot be selected.
89
"Restorer" cannot • Check that an analog signal or PCM signal (Sample Rate=44.1/48
be selected. kHz) is input. For playback of multichannel signals such as Dolby
–
Digital or DTS surround, "Restorer" cannot be used.
• Switch the sound mode to other than "DIRECT".
GFM/AMH
–
Symptom
Reception fails, or • Change the antenna orientation or position.
76
there is a lot of noise • Separate the AM loop antenna from the unit.
–
or distortion. • Use an FM outdoor antenna.
99
• Separate the antenna from other connection cables.
99, 101
97
9, 10
125
Cause/Solution
Cause/Solution
Page
99
–
69
–
20
88
69
Page
17
17
17
17