Denon AVR-E300 Owner's Manual page 104

Setting items
Bass Subwoofer Mode : Select low range signals to be reproduced by
Set subwoofer and LFE subwoofer.
signal range playback. • LFE : The low range signal of the channel set to "Small" speaker size is
added to the LFE signal output from the subwoofer.
• LFE+Main : The low range signal of all channels is added to the LFE
signal output from the subwoofer. This is usually the best setting for
most systems.
• "Subwoofer Mode" can be set when "Speaker Config." – "Subwoofer"
(vpage 99) is set to other than "No".
• Play music or a movie source and select the mode offering the strongest
bass.
• Select "LFE+Main" if you want the bass signals to always be produced
from the subwoofer.
NOTE
If "Front" and "Center" for "Speaker Config." are set to "Large", and
"Subwoofer Mode" is set to "LFE", no sound may be output from the
subwoofers, depending on the input signal or selected sound mode.
LPF for LFE : Set LFE signal playback range. Set this when you want to
change the playback frequency (low pass filter point) of the subwoofer.
• 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz
DVD
Speakers
Setting details
101