Table of Contents
Advertisement
Setup
CAm TITle :
If you enter a title, the title will appear on the monitor.
1 If the SPECIAL menu screen is
displayed, use the Function Setup
switch so that the arrow indicates
'CAM TITLE'.
2 Set it to 'ON' by using the Function
Setup switch.
➌ Press the Function Setup switch.
Use the Function Setup switch to move
4
to a desired letter and select the letter
by pressing the switch. Repeat this to
enter multiple letters. You can enter
5 Enter a title, move the cursor to 'POS'
and press the Function Setup switch. The
entered title appears on the screen. Select
the position to display the title on the screen
by using the Function Setup switch and
press. When the position is determined,
select 'END' and press the Function Setup
switch to return to the SPECIAL menu.
When the CAM TITLE menu is 'OFF', no title will be displayed on the monitor screen even if you
enter one.
Only English is available in the mode.
If you move the cursor to CLR and press the Function Setup switch, all the letters are deleted.
To edit a letter, change the cursor to the bottom left arrow and press the Function Setup switch.
Move the cursor over the letter to be edited, move the cursor to the letter to be inserted and then
press the Function Setup switch.
syNC : In areas where the supply is
at 60Hz(NTSC), 50Hz(PAL), you can
synchronize the output phase of multiple
cameras using the power synchronization
function (Line-Lock) without using a
synchronization signal generator.
30_ Setup
CAMERA TITLE SETUP
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
a b c d e f g h i j k l m
n o p q r s t u v w x y z
- . 0 1 2 3 4 5 6 7 8 9
← → C L R P O S E N D
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
up to 15 letters.
FRONT DOOR
▶ PHASE
Press SET to Return
SYNC
IIIIIIIIIIIIIIIIIIIII
0
Advertisement
Table of Contents
