Samsung SCO-2370 User Manual page 17

setup
DAY/NIGHT : You can display pictures in
color or black and white.
➊ When the SETUP menu screen is
displayed, select 'DAY/NIGHT' using the
Function Setup switch so that the arrow
indicates 'DAY/NIGHT'.
➋ Select a desired mode using the Function
Setup switch according to the picture
display you want.
AUTO : The mode is switched to 'Color' in
a normal environment, but switches to
'B/W' mode when ambient illumination
is low. To set up the switching time
or speed for AUTO mode, press the
Function Setup switch.
COLOR : The picture is always
displayed in color.
B/W : The picture is always displayed in
black and white.
- DWELL TIME : You can select tday/
night switching delay time from.
5,7,10,15,20,30,40, 60(sec)
- DURATION : You can select the day/night switching point(lux).
Fast
Slow
When AGC is middle mode.
EXT : This mode allows you to apply a desired filter to external signals.
M 
You cannot control the DAY/NIGHT menu when AGC in the EXPOSURE menu is 'OFF'.
At this time, the exchange between DAY mode and NIGHT mode operates as like selecting
'COLOR' mode.

The OSD key does not work for 3 seconds when switching to Color or B/W, to ensure stable
camera operation.

The camera may focus less well under infrared illumination than under normal illumination.

The brightness of illumination is changeable by installed environment.
32_ setup
SPECIAL SETUP
PRIVACY OFF
DAY/NIGHT AUTO
DIS OFF
SYNC INT
COMM ADJ
IMAGE ADJ
MONITOR LCD
DISPLAY
RETURN
AUTO SETUP
DWELL TIME 5 SEC
DURATION SLOW
RETURN
Color B/W B/W Color
2.6Lux 4.2Lux
1.2Lux 6.0Lux
DIS : The DIS mode can compensate for
vibration of the camera.
M 
When DIS is operating, D-ZOOM does not
operate.
SYNC : Two synchronization modes are available INTERNAL and EXTERNAL
LINE-LOCK.
In LINE-LOCK mode, it synchronizes the camera's video out signal to the
external SYNC signal.
- INT : Internal synchronization
- LL : External line-lock synchronization
➊ If you choose 'LL', you can adjust the desired phase.
Press the Function Setup switch.
➋ You can adjust the desired phase from 0 to 359.
COMM ADJ (Communication Adjustment) :
This function sets up the camera
communication status when controlling the
camera through an external controlled device.
➊ When the SPECIAL menu screen is
displayed, using the Function Setup
switch so that the arrow indicates
'COMM ADJ'.
➋ Set up the mode moving the 4 direction
of the Function Setup switch.
- PROTOCOL : Select the communication PROTOCOL. (SAMSUNG-T/PELCO-D/
PELCO-P/ BOSCH/HONEYWELL/VICON/AD/SAMSUNG-E/PANASONIC)
- CAM ID : Determines the camera's identifi cation number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
SPECIAL SETUP
PRIVACY OFF
DAY/NIGHT AUTO
DIS OFF
SYNC INT
COMM ADJ
IMAGE ADJ
MONITOR LCD
DISPLAY
RETURN
COMMUNICATION SETUP
PROTOCOL SAMSUNG-T
CAM ID 1
IIIIIIIIIIIIIIIIIIIIIIIIIIIII
BAUD RATE 9600
UART MODE 8-N-1
RET PKT DISABLE
RETURN
English_33