Tank Assembly - Grizzly H8226 Instruction Manual

Pump Assembly
Lift Handle
Safety Valve
Fluid Outlet Adapter
To assemble the paint tank:
1. Attach the casters to the bottom of the
paint tank.
2. Connect a / NPT air supply hose (not
1
4
included), to the inlet fitting on the regu-
lator (Figure 2).
3. Connect the machined compression
hose fitting and the
sion nut to the fluid outlet adaptor.
Figure 3. Paint tank connect to air compressor and spray gun.
Install a pressure regulator (not included),
between the tank regulator assembly
(Figure 3) and the spray gun.
Figure 3 depicts the paint tank connected
to a compressed air system with a filter/
regulator unit and a spray gun.
-6
-

Tank Assembly

Figure 2. Lid assembly identification.
/ " NPT compres-
3
8
Model H8226 5 Gallon Automatic Mixing Paint Tank
Regulator Assembly
4. Connect the material hose (not includ-
ed), to the fluid outlet adapter.
5. Connect the barbed compression hose
fitting and the
nut to the outlet fitting.
6. Attach the atomization air hose (not
included), to the air outlet fitting on the
regulator.
The filter/regulator unit will protect your
tool from damaging water build-up, and
allow you to adjust and maintain regulated
air pressure. If you plan on installing a
filter/regulator unit in your compressed
air system, always follow the connection
instructions that come with the unit.
Inlet Fitting
Outlet Fitting
/ " NPT compression
1
4