Steering - Cannondale E440 2003 Owner's Manual

ting tabs in first. Then inspect the O-rings for any
damage (e.g., swelling, distortion, tears, rips,
etc.) and replace if necessary. Apply a light coat
of clean engine oil to the O-rings, and insert the
hoses into the tank until the fittings lock. The fit-
ting should make an audible click when locked
properly.
5. Reinstall removed components. See page 96.
LUBRICATE
O-RING
BEFORE
INSERTING
73 73
Idle speed adjustment
Idle speed: 2100 - 2,200 r/min
A special software diagnostic tool is required to
accurately read (display) the engine rpm. For this
reason, we strongly recommend that this procedure
be left to a Cannondale Service Technician.
Attempting to adjust the idle "by ear" is not recom-
mended.
Idle adjuster
1.
a. Increase rpm
b. Decrease rpm
The idle speed adjustment screw is located on the
throttle body and is accessible from the left side of
the vehicle.

STEERING

Adjusting the handlebar position
The handlebar position can be adjusted rearward
from the factory-set position by removing the lower
handlebar clamps and rotating them 180°.
IDLE ADJUST
Printed : 8/15/02