your vehicle. With the tool, you can read fault codes,
install engine calibration files, set vehicle rpm, and
monitor engine operating parameters.
Diagnostic connector
1.
ECU power relay
2.
Main fuse
3.
ELECTRICAL
Replacing the fuses
Main fuse (rating): 10A
Lighting fuse (rating): 10A
Fuses are located under the seat.
Main fuse
1.
Lighting fuse
2.
EMS power relay
3.
WARNING
2003 Motorcycle OM.fm
© 2002 Cannondale Corporation - All Rights Reserved
POTENTIAL HAZARD
Using an improper fuse.
WHAT CAN HAPPEN
An improper fuse can cause damage to the
electrical system which could lead to a fire.
HOW TO AVOID THE HAZARD
Only use a replacement fuse of the specified
rating. Never use other materials in place of the
fuse. Always turn OFF the ignition switch when
checking or replacing the fuse. Otherwise, a
short circuit may occur.
Check the condition of the wiring harness and
connectors before replacing a blown fuse.
1. To replace a fuse, remove the seat. See seat
2. Use a thin blade screwdriver to lift up on the
1.
2.
3.
3. Pull the bottom of the fuse socket toward the
CAUTION :
Do not pull on the wires.
4. Remove the fuse, and install the specified
Indicates a potential hazard that could result in serious injury or death.
62
WARNING
removal in this manual.
latch.
Fuse socket
Latch
Fuse housing
front of the vehicle.